User's Manual

5 2
Remove the Road Rippers R/C vehicle and controller from the box. Insert 3 “AAA” batteries in the
controller. Add 4 “AA” batteries into the Road Rippers R/C vehicle to begin full function play
(see “Battery Installation” section for further details).
TREAT YOUR ROAD RIPPERS R/C VEHICLE WELL
Radio waves control the Road Rippers R/C vehicle. Care for your vehicle and it will provide hours of fun!
Avoid water, heat, sand and high impact crashes!
Store in safe place. No direct sunlight.
No rain or water.
No sand or dust. No Collisions. Road Rippers R/C vehicle may get
stuck on carpet or grass.
Avoid running 2 vehicles with the same
radio control frequencies.
CLEANING AND MAINTAINING
Brush areas where dirt and dust
get trapped.
Wipe body off with a soft rag or
tact cloth.
Do not clean vehicle with
chemicals or water.
GETTING STARTED
BATTERY INSTALLATION IN CONTROLLER
LOOSEN SCREW
TO OPEN
3 "AAA" BATTERIES REQUIRED
(NOT INCLUDED)
TO REPLACE THE BATTERIES
NOTE:
For best performance, always use alkaline batteries only.
BATTERY INSTALLATION IN ROAD RIPPERS R/C VEHICLE
4 "AA" BATTERIES REQUIRED (NOT INCLUDED)
TO REPLACE THE BATTERIES
LOOSEN
SCREW
TO OPEN
2. Insert 3 “AAA”
batteries into
the Controller.
Be sure the +
and – are
properly
matched.
2. Insert 4 “AA”
batteries into
the Vehicle.
Be sure the +
and – are
properly
matched.
1. To remove battery cover, loosen
screw to open.
1. To remove battery cover, loosen
screw to open.