User's Manual

Operating Instructions For Bluetooth Speaker

There are two ways to play music through the blue tooth speaker – SD Card or through your portable device

1. To play through your SD Card

1) Make sure the bluetooth speaker is plugged and push mode button until a red light appears on top of

the speaker.

2) SD Card – plug your SD card into the backside of the speaker.

** note** The SD Card must be pre-loaded with the music you desire to play.

** Note**

Under SD mode, You can increase the volume FURTHER by using the volume buttons on the top

of the speaker (as shown below). Make sure you hold down the volume button in order to adjust the volume

setting (long press)

The music on the SD card can also be controlled through the buttons on top of the speaker as shown below.

Use “short press” to activate this.

PAGE 1
Operating Instructions For Bluetooth Speaker There are two ways to play music through the blue tooth speaker – SD Card or through your portable device 1. To play through your SD Card 1) Make sure the bluetooth speaker is plugged and push mode button until a red light appears on top of the speaker. 2) SD Card – plug your SD card into the backside of the speaker. ** note** The SD Card must be pre-loaded with the music you desire to play.
PAGE 2
REVERSE – to previous song Power ON/OFF Pause/play FAST FORWARD – to next song Switch between SD Card and Blue tooth mode 2. TO PLAY THROUGH YOUR WIRELESS DEVICE: 1) Make sure the bluetooth speaker is plugged in and push mode button until a blue light appears on top of the speaker. 2) Make sure the blue-tooth name “ Glo-TEC” is highlighted on your device. 3) Ensure the bluetooth setting is activated on your device and paired with the speaker before playing music.
PAGE 3
FCC Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.