User's Manual

3. Fast Chasing left to right from one light set to another
4. Slow to fast chasing right to left from one light set to another.
5. Slow to fast chasing left to right from one light set to another.
6. Flashing/Chasing combination
7. Alternating flashing
8. Bi-Directional Pulsing
9. Bi-directional Chasing
10. Strobing
11. Random Flashing
12. Bi-directional chasing with flashing
13. Pulsing to Strobing feature.
14. Bi-Directional Strobing
15. Fade in / Fade out
16. Steady on
(b) Sensor mode
As music plays through the speaker with blue tooth feather or memory card, the lights will dance and
flash to the rhythm of the music.
Press the button “ Sensor “ on the panel of remote controller.
Insert the Memory card to the slot, Power on the speaker and the light indicator on the panel is red, the
controller can work under SD card Mode;
pressing the button “ Mode” and the light indicator is blue, the controller cand work under “ blue tooth”
Mode, the speaker can play music sent from your mobile phone or ipod.
Press the “volume” control bar to adjust the volume level as you desire.
Change the songs just press the backward or forward button.
NOTES:
1. Light set must be plugged into working outlet for remote control to function.
2. The remote control unit is the only way to change the function setting of this product.
3. When using the remote to turn your set ON, there may be a slight delay before the light pattern starts
working.
4. To change the light pattern, it is recommended to wait a few seconds after each time you press the
“FUNCTION” button until you reach the desired pattern/function.
5. If the lights do not change function or the set does not turn on or off with the remote, see the trouble
shooting section.
6. If there is a power interruption, including if used on a switched outlet, on a timer, or power failure, the
system’s memory will retain the last light pattern displayed.
7. The operating distance of the remote is up to 100 feet ( 30meters). Distance may vary due to other
radio transmitters in the area (cell phones, Wi-Fi signals, wireless phones, intercoms, baby monitor,
etc.), microwave ovens, computers, materials used in the construction of your home, trees, hills,
bushes and other items that may attenuate the radio signal.
8. The battery in the remote will drain and become depleted very quickly if the remote is place where
one (or both) of the buttons on the remote are continually pushed (such as placing an item on top
of them, or storing the remote upside down).
NOTES:
A. When multiple light sets are lighted, pressing the FUNCTION button will change all sets to the next
pattern. If the set are preprogrammed, then they should all change to the same next pattern.
B. These are Radio Frequency controlled devices. All sets within the effective range will be affected
and controlled using any one remote.
C. If used with a mechanical / digital timer, only one timer must control all sets. In this case, do not turn
sets off using the remote or the sets will not turn on with the timer.