Owner's Manual

Page 6 TOYOTA RS3200 PLUS Security system
OPERATION
DISARMING THE RS3200 PLUS (except PASSIVE DISARMING)
The system may be DISARMED in several ways. Do one of the following:
Unlock the doors with your key:
Insert the key into the door key switch and turn it toward the rear of
the vehicle:
The S
TATUS MONITORS LED stops flashing. The system is
now DISARMED.*
In the case of Highlander, Sienna, and 4Runner, you may also disarm
the system using the key in the back door; all doors will unlock at the
same time.
Unlock the doors with the remote control:
Press the unlock button on the remote control. Simultaneously:
The driver’s door unlocks.
The vehicle’s tail and marker or turn signal lights flash
twice.
The vehicle’s buzzer chirps twice.
The S
TATUS MONITORS LED stops flashing. The system is
now DISARMED.*
Press the unlock button again within 3 seconds after unlocking the
driver’s door to unlock the remaining doors.
NOTE: If your vehicle’s tail and marker or turn signal lights turn on for 2 seconds when the system
is D
ISARMED,* the TRIGGER MEMORY was activated; something TRIGGERED an ALARM while
you were away from the vehicle. This feature is not available for Corolla / Matrix.
* Please note, if the system utilizes your vehicle’s engine immobilizer system LED instead of the
S
TATUS MONITOR, the LED will continue to flash.
If your vehicle is equipped with a buzzer.
TURN TOWARD THE
REAR
OF THE VEHICLE
THE DRIVER’S DOOR
UNLOCKS WHEN THE
SYSTEM IS REMOTE
DISARMED
THE TAIL AND MARKER OR TURN SIGNAL
LIGHTS FLASH TWICE WHEN THE SYSTEM
IS REMOTE DISARMED
PUSH THE UNLOCK
BUTTON
STOPS
FLASH-
ING
WHEN
THE SYS-
TEM IS
DIS-
ARMED
Página 6 TOYOTA RS3200 PLUS SISTEMA DE SEGURIDAD
GIRE HACIA LA PARTE TRASERA
DEL VEHÍCULO
PRESIONE EL BOTÓN PARA
DESASEGURAR LAS PUERTAS
(UNLOCK)
EL SEGURO DE LA PUERTA DEL
CONDUCTOR SE ABRE AL
DESARMAR REMOTAMENTE EL
VEHÍCULO
LAS LUCES TRASERAS E INTERMITENTES PARPADEAN DOS
VECES AL DESARMAR REMOTAMENTE AL SISTEMA
DEJA DE
PARPADEAR AL
DESARMAR EL
SISTEMA
3
2
1
OPERACIÓN
DESARMADO DEL RS3200 Plus (excepto DESARMADO PASIVO)
El sistema podrá ser desarmado de varias maneras. Haga una de las siguientes:
Desasegure las puertas con su llave:
Inserte la llave en el interruptor de la puerta y gírela hacia la parte trasera
del vehículo:
El LED que monitorea el condición del sistema dejará de parpadear. (1)
El sistema se encuentra ahora desarmado.
En caso del Highlander, Sienna y el 4Runner, también podrá
desarmar el sistema empleando la llave desde la puerta trasera;
todas las puertas se desasegurarán al mismo tiempo.
Desasegure las puertas a través del control remoto:
Presione el botón para desasegurar las puertas desde el control remoto.
Simultáneamente:
La puerta del conductor se desasegura. (2)
Las luces traseras e intermitentes del vehículo centellearán dos veces. (3)
El zumbador del vehículo sonará dos veces.
El LED que monitorea el condición del sistema deja de parpadear. (1)
El sistema se encuentra ahora desarmado.
Presione el botón para desasegurar las puertas nuevamente dentro de
los siguientes tres segundos después de haber desasegurado la puerta
del conductor, para desasegurar el resto de las puertas.
NOTA: Si las luces traseras e intermitentes se encienden durante dos segundos al desarmar el
sistema, * significa que la memoria de disparo fue activada; algo hizo sonar la alarma
mientras usted no estaba presente.
* Por favor note que, si su automóvil emplea el LED del inmovilizador del vehículo para
monitorear la condición del sistema de alarma, el LED continuará parpadeando.
Sólo en caso de que su vehículo esté equipado con un zumbador.
1
2
3
1