Operation Manual

42
Special specifications
IV. Special specifications
1. Using the needle threader
Before using the needle threader, remove the power plug from the outlet.
Not doing so could cause an injury.
Turn the handwheel towards yourself to raise the
needle to the highest position.
(in the direction of the arrow)
Note : Always turn the handwheel towards your-
self. If you turn it in the reverse direction it
could tangle the thread.
Lower the presser foot lever.
Slightly lower the needle threader lever, and set
the thread you are holding in your right hand from
the right side of the hook guide.
Fully press down the needle threader lever to
pass the hook through the needle eye.
Make sure that the hook is in the needle eye.
Note : If the hook is bent and cannot pass through
the needle eye, straighten it with a screw
driver.