Operation Manual

14
Sewing preparations
1. Move the declutch latch
in the direction
(in the direction of the
arrow)
(This ensures that the
needle does not move.)
2. Pass the thread from the
inside through the bobbin
hole.
3. Set the bobbin on the
thread winding spindle
and move the spindle to
the right (in the direction
of the arrow)
1. Holding the end of the
thread, step on the foot
controller to wind the
thread.
2. After winding it a little,
stop the sewing machine
and cut the thread that
protrudes from the bobbin
hole.Then continue wind-
ing the thread.
After the winding has
finished, move the thread
winding spindle back to the
left. (in the direction of the
arrow)
1. Remove the bobbin and cut the thread.
2. Move the declutch latch in the direction
(in the direction of the arrow)
Note : If the declutch is not returned to its original
position, the sewing machine cannot move
and will not sew.