Operation Manual

2
15
Sewing preparations
Pull the thread from the thread
spool, and then hold it with
one hand while passing it
around the thread guide with
the other hand, as shown.
Pass the thread end through
the hole in the bobbin as
shown.
Place the bobbin on the
thread winding spindle so the
groove aligns with the shaft
projection.
7
While holding the thread end,
1
begin pressing on the foot
controller with your foot.
After the thread has been
2
wound around the bobbin
about 10 times, release
the foot controller to stop
winding.
Spool pin (
2
)
Thread winding spindle
(
7
8
10
)
Foot controller
(
7
9
)
Main power switch
(
1
6
)
Thread guide
Thread
Hole
Thread
winding
spindle
Groove
Bobbin
Shaft
projection
Slide the
thread winding
spindle in the
direction of
the arrow until
it snaps into
place.
6
Turn on the machine.
Main power switch
Foot controller
Hold in place
with your finger.
While the bobbin is being wound, do not touch the thread winding
spindle or the handwheel.
Doing so could cause an injury.
Caution