Operation Manual

49
English Français
Nederlands Italiano
ABC
Adjusting stitch balance of buttonhole
Occasionally (especially on speciality fabrics) the
stitch length shows differences in forward and reverse
stitches of the buttonhole.
Stitch balance can be equalized by turning the
Buttonhole Stitch Adjuster. (fig A)
1. If the stitches of the right side of the buttonhole
(forward stitches) are too close together, turn the
adjuster clockwise using a screw driver or a coin.
(fig B)
2. If the stitches of the left side of the buttonhole
(reverse stitches) are too close together, turn the
adjuster counterclockwise. (fig C)
Ajuster l’équilibre des points de la boutonnière
Parfois (surtout pour des tissus particuliers) la
longueur de point montre des différences entre les
points crées en marche avant et les points crées en
marche arrière pour réaliser la boutonnière.
L’équilibre des points de boutonnières s’obtient en
tournant le sélecteur de mise au point (fig. A)
1. Si les points du côté droit de la boutonnière (point
en avançant) sont trop rapprochés, tourner le
sélecteur de mise au point dans le sens des
aiguilles d’une montre en utilisant un tournevis ou
une pièce. (fig. B)
2. Si les points du côté gauche de la boutonnière
(points en reculant) sont trop rapprochés, tourner
le sélecteur de mise au point dans le sens contraire
des aiguilles d’une montre. (fig. C)
Instellen van de steekbalans van het knoopsgat
Af en toe (vooral mat speciale stoffen) vertonen de
lengtesteken verschillen in de voorwaartse en
achterwaartse steken van het knoopsgat.
De steekbalans kan gelijk gemaakt worden door aan
de knoopsgat steek instellingsknop te draaien (fig A)
1. Als de steken aan de rechterkant van het
knoopsgat (voorwaartse steken) te dicht op elkaar
zitten, draait u de afstellingsknop rechtsom met
een schroevendraaier of een munt. (fig B)
2. Als de steken aan de linkerkant van het knoopsgat
(achterwaartse steken) te dicht op elkaar zitten,
draait u de afstellingsknop linksom. (fig C)
Bilanciamento dei lati sinistro e destra
dell’asola
Su tessuti diversi, i punti sinistro e destro possono
risultare non bilanciati.
In tal caso regolare il bilanciamento dei punti ruotando
l’apposito controllo (fig. A) posto dietro la macchina
1. Se i punti del lato destro dell’occhiello sono troppo
vicini, ruotare il controllo a sinistra come mostrato
in (fig. B)
2. Se i punti del lato sinistro dell’occhiello sono troppo
vicini, ruotare il controllo a destra come mostrato in
(fig. C)
RS2000-2D_EFNI.book Page 49 Wednesday, July 27, 2005 7:39 AM