Operation Manual

1-4. Opening and closing the windows

FT86_EE

 When the power window does not close normally

If the jam protection function is operating abnormally and a window cannot

be closed, close all the doors and perform the following operations using the

power window switch on the relevant door.

Vehicles without a smart entry & start system: After stopping the

vehicle, the engine switch is turned to the “ON” position.

Vehicles with a smart entry & start system: After stopping the vehi-

cle, the “ENGINE START STOP” switch is turned to IGNITION ON

mode.

Hold the power window switch in the one-touch closing position two

consecutive times.

Hold the power window switch in the one-touch closing position

once again and continue holding for 1 second or more after the win-

dow closes completely.

If you push the power window switch to the opening position while the win-

dow is moving, start again from the beginning. If the window continues to

close but then re-open slightly even after performing the above procedure

correctly, have the vehicle inspected by any authorized Toyota dealer or

repairer, or another duly qualified and equipped professional.

CAUTION

 Closing the windows

Observe the following precautions.

Failure to do so may result in death or serious injury.

 Check to make sure that all passengers do not have any part of their body

in a position where it could be caught when a window is being operated.

 Do not allow children to operate the power windows.

Closing a power window on someone can cause serious injury, and in

some instances, even death.

 Jam protection function

 Never use any part of your body to intentionally activate the jam protection

function.

 The jam protection function may not work if something gets caught just

before the window fully closes.

STEP