Operation Manual

403

5-2. Steps to take in an emergency

When trouble arises

FT86_EE

Turn the compressor switch “ON”

and fill the tire with air until the

specified inflation pressure is

reached.

Turn the switch “OFF” when the pressure gauge connected to

the hose reads the specified pressure.

If the inflation pressure is not attained within 10 minutes, emergency

repair is not possible due to severe damage. Contact any authorized

Toyota dealer or repairer, or another duly qualified and equipped pro-

fessional.

After completely filling the tire with air, disconnect the hose

from the valve on the tire and pull the power plug of the com-

pressor out of the power outlet on the vehicle.

To spread the liquid sealant evenly in the tire, immediately

drive for about 10 minutes.

After driving about 10 minutes,

pull your vehicle over in a safe

place and reconnect the com-

pressor.

STEP

Switch

STEP

86_OM_EE_OM18058E.book 403 ページ２０１５年３月１７日　火曜日　午前１１時３１分