Operation Manual

412

5-2. Steps to take in an emergency

FT86_EE

Emergency start function (vehicles with a smart entry & start system)

When the engine does not start, the following steps can be used as

an interim measure to start the engine if the “ENGINE START STOP”

switch is functioning normally:

Vehicles with an automatic transmission

Set the parking brake.

Put the shift lever in P.

Set the “ENGINE START STOP” switch to ACCESSORY

mode.

Press and hold the “ENGINE START STOP” switch about 15

seconds while depressing the brake pedal firmly.

Even if the engine can be started using the above steps, the system

may be malfunctioning. Have the vehicle checked by any authorized

Toyota dealer or repairer, or another duly qualified and equipped pro-

fessional.

■ The starter motor does not turn over, the interior lights and

headlights do not turn on, or the horn does not sound.

One of the following may be the cause of the problem.

● One or both of the battery terminals may be disconnected.

● The battery may be discharged. (→P. 420)

● There may be a malfunction in the steering lock system. (vehi-

cles with a smart entry & start system)

Contact any authorized Toyota dealer or repairer, or another duly

qualified and equipped professional if the problem cannot be

repaired, or if repair procedures are unknown.

STEP

86_OM_EE_OM18058E.book 412 ページ２０１５年３月１７日　火曜日　午前１１時３１分