Operation Manual

59
EN
❑ When using the zigzag sewing foot
1 Select the stitch in the operation panel.
* Check that the OEKAKI (free-motion embroidering) button is not lit.
* When sewing thin fabrics, select stitch number 5.
* When sewing stretch fabrics, select stitch number 13, 15, 18, 22 or 26.
* Refer to “Selecting the stitch” (page 44).
2 Select the stitch width and stitch length.
* Refer to “Selecting the stitch width” (page 45) and “Selecting the stitch length” (page 46).
3 Press the (needle up/down) button to raise the needle.
4 Position the fabric under the presser foot, and then lower the presser foot lever.
5 Position the fabric so that the needle extends
slightly off the edge of the fabric when the
needle moves to the right.
OEKAKI
button
not lit
Suitable stitch
13
5
15
18
22
26
Presser foot to be used
Zigzag
sewing
foot
Right needle entry point