Operation Manual

455

8-2. Steps to take in an emergency

When trouble arises

 1ND-TV engine

Connect a positive jumper cable clamp to the positive (+) battery

terminal on your vehicle.

Connect the clamp on the other end of the positive cable to the

positive (+) battery terminal on the second vehicle.

Connect a negative cable clamp to the negative (-) battery termi-

nal on the second vehicle.

Connect the clamp at the other end of the negative cable to a

solid, stationary, unpainted metallic point away from the battery

and any moving parts, as shown in the illustration.

Start the engine of the second vehicle. Increase the engine speed

slightly and maintain it at that level for approximately 5 minutes to

recharge the battery of your vehicle.

Vehicles with a smart entry & start system: Open and close any of

the doors of your vehicle with the engine switch off.

Maintain the engine speed of the second vehicle and turn the

engine switch to “ON” position (vehicles without a smart entry &

start system) or IGNITION ON mode (vehicles with a smart entry &

start system), then start the vehicle’s engine.