User's Manual

(Diagram 7)
(Diagram 1)
(Diagram 2)
(Diagram 3)
(Diagram 6)
(Diagram 5)
Backward
Forward
Straight
Turbo
Left
On
Off
Stop
Right
B
F
R
R
L
L
1:16 Incredible Instruction
Prints 1 Color Process Black
Folded size: 65mm x 121mm
Extended size: 392mm x 121mm
USING 6V BATTERY PACK:
1. Slide ON/OFF switch on the bottom of the
vehicle to OFF.
2. Insert battery pack into the battery
compartment as shown. (See diagram 2)
3. Push battery pack forward in direction of arrow
engraved on battery pack.
4. Use a coin to turn the battery compartment
latch counterclockwise until it stops to lock the
battery pack in position.
When the vehicle slows down, recharge the
battery pack. When the battery pack will no
longer hold a charge, replace it.
Note: To remove, use a coin to turn the battery
compartment latch clockwise until it stops, slide
the battery pack up and remove it from the
battery compartment.
© Disney / Pixar
FAST LANE is a mark of Geoffrey, Inc.
© Geoffrey, Inc.
Distributed by Toys“R”Us, Inc.,
Wayne, NJ 07470
Made in China
www.toysrus.com
DRIVING THE CAR:
Warning: Never play with your vehicle in the street.
1. Slide ON/OFF switch on the side of the vehicle
to ON. (See diagram 5)
2. Use the transmitter’s control levers as follows:
(See diagram 6)
Left Control Lever:
Push forward to move forward (F).
Pull back to move backward (B).
Release to stop.
Right Control Lever:
Push left to move left (L).
Push right to move right (R).
Release to go straight.
TURBO:
Press "Turbo" button for maximum power.
Caution: If the vehicle gets stuck under an
object, immediately release the control levers
on the transmitter, then retrieve the vehice.
3. When you finish driving, slide the ON/OFF
switch on the vehicle to OFF.
HOW TO OPERATE:
1. If the vehicle does not go in a straight line when
you release the right control lever, adjust the
wheel alignment control on the bottom of the
vehicle. Turn the wheel alignment control
toward L if the vehicle is pulling to the right,
or toward R if the vehicle is pulling to the left.
(See diagram 7)
HELPFUL HINTS:
The following hints can help you get the most
enjoyment from your vehicle:
Running your vehicle continuously for long
periods generates high heat levels. Heat
causes wear and tear on the motor. When
your vehicle’s battery dies, let the vehicle cool
at least 10 minutes before installing a newly
charged battery pack. This helps keep heat
levels down.
If the vehicle’s motor runs but does not
respond to the transmitter, move closer to the
vehicle and try again.
If someone uses a CB nearby, it might
interfere with control of the vehicle. If this
happens, move the vehicle and transmitter
away from the CB.
You cannot operate your vehicle near devices
with transmitters that use the same frequency,
(27 MHz or 49 MHz). Check the packaging
to see which frequency your vehicle uses.
If the vehicle moves slowly, and you have
installed a recharged battery pack, check the
wheel mechanisms for lint, thread, hair or dust.
CARE:
The following suggestions will help you care for
your vehicle so you can enjoy it for years:
Never drive the vehicle on a wet floor, on
sand, or in mud, rain, or snow. These can
damage it.
Do not expose the vehicle to extreme
temperatures.
To protect the vehicle’s wheel mechanisms
from lint and hair, do not drive it on carpet.
Occasionally wipe the vehicle with a damp
cloth to keep it looking new. Do not use harsh
chemicals to clean the vehicle.
Modifying or tampering with the vehicle or the
transmitter’s internal components can cause a
malfunction and void your FCC authorization to
operate them.
THE FCC WANTS YOU TO KNOW:
Your vehicle or transmitter might cause TV or
radio interference even when it is operating
properly. To determine whether your vehicle or
transmitter is causing the interference, turn off
your vehicle and release the transmitter’s control
levers. If the interference goes away, your vehicle
or transmitter is the cause.
Try to eliminate the interference by:
Moving your vehicle and transmitter away from
the TV or radio.
If you cannot eliminate the interference, the FCC
requires that you stop using your vehicle.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
BATTERY INSTALLATION:
TRANSMITTER:
The transmitter requires one 9-volt battery
(not included). For the best performance and
longest life, we recommend an alkaline battery.
Follow these steps to install the battery in
the transmitter:
1. Remove battery compartment cover by sliding
it in the direction of the arrow shown on the
compartment cover.
2. Place battery in the compartment according to
the polarity symbols (+ and -) marked inside.
(See diagram 1)
3. Replace the cover and snap it shut.
When the transmitter’s range decreases, replace
battery.
CAR:
Your vehicle requires a 6-volt rechargeable battery
pack (not included) or 4 x AA batteries (not
included).
6
USING 4 X AA BATTERIES:
1. You can use 4 x AA batteries (Alkaline,
Rechargeable NiMH, or Rechargeable NiCd)
to power your vehicle by using the AA Battery
Adaptor provided.
2. Insert 4 x AA batteries in the AA Battery
Adaptor according to the polarity symbols
(+ and -) marked inside. (See diagram 3)
3. Insert AA Battery Adaptor, as battery pack
with AA batteries facing down into the battery
compartment as shown.
Follow steps 2, 3 and 4 of USING 6V
BATTERY PACK.
ATTENTION PARENTS:
IT IS RECOMMENDED THAT THIS TOY
AND ALL ACCESSORIES BE
PERIODICALLY EXAMINED FOR
POTENTIAL HAZARDS AND THAT ANY
POTENTIALLY HAZARDOUS PARTS
BE REPAIRED OR REPLACED.
OPERATING INSTRUCTIONS
BATTERY PACK CARE / CAUTIONS:
Use only a fresh battery and/or battery pack of
the required size and type.
If you do not plan to use the vehicle for several
days, remove the battery from the transmitter
and the battery pack from the vehicle.
Do not mix old and new batteries. Do not mix
alkaline, standard (carbon zinc), or
rechargeable (nickel-cadmium) or
Ni-MH batteries.
Never leave dead or weak batteries in the
vehicle.
Dispose of old batteries promptly and properly;
do not bury or burn them.
Do not charge non-rechargeable batteries.
Insert batteries with the correct polarity.
Do not short the supply terminals.
Remove rechargeable batteries from the
vehicle before being charged.
Keep the package and owner’s manual since
it contains important information.
AA Battery Adaptor
Battery compartment latch
RADIO CONTROL
INCREDOBILE
L
H

Summary of content (1 pages)