User's Manual

ManualsBrandsTOYS ManualsToys & Games49.82-49.90MHz WIRELESS R/C TOY-TX

Owner’s Manual – 2314

Read Owner’s Manual carefully and completely before operating the Motorcycle.

Battery Requirement: : One (1) 9V battery for transmitter

One (1) 7.2V battery pack for Motorcycle

Installing the Battery in the Transmitter

1. Slide the battery compartment cover in the direction

of the arrow on the cover to remove it.

2. Install the 9V battery in the compartment in

accordance to the polarity symbols (+ and -)

marked inside.

3. Replace the cover and snap it shut.

Note: When the range of transmitter decreases,

replace with a new battery.

Installing Battery in the Motorcycle

1. Turn the ON/OFF switch on the side of

the Motorcycle to OFF.

2. Loosen the screw on the battery

compartment cover located on the

bottom of the motorcycle and remove the

cover.

3. Install the 7.2V battery pack in the

compartment. Make sure the battery

pack in fully charged before use. Attach

the battery pack’s white plastic connector

to the motorcycle’s matching connector.

Do not force them together. They only

fit one way.

4. Replace the cover and secure it with the

screw.

Summary of content (6 pages)

PAGE 1
Owner’s Manual – 2314 Read Owner’s Manual carefully and completely before operating the Motorcycle. Battery Requirement: : One (1) 9V battery for transmitter One (1) 7.2V battery pack for Motorcycle Installing the Battery in the Transmitter 1. Slide the battery compartment cover in the direction of the arrow on the cover to remove it. 2. Install the 9V battery in the compartment in accordance to the polarity symbols (+ and -) marked inside. 3. Replace the cover and snap it shut.
PAGE 2
Installing the Antenna 1. Route the loose end of the motorcycle’s antenna wire through the supplied antenna tube. 2. Insert the tube securely into the motorcycle’s tube holder. Driving The Motorcycle 1. Extend the transmitter’s antenna to its full length before driving the motorcycle. For maximum range, hold the transmitter with the antenna as high as possible and point it straight up. 2. Turn the Motorcycle and Transmitter’s ON/OFF switch to ON. The LED indicator on the transmitter illuminates. 3.
PAGE 3
6. Use the Transmitter’s control levers to drive and steer your Motorcycle as follows: ▪ Push Left Control Lever forward to move Forward. ▪ Push Left Control Lever forward and Right Control Lever left to move Left. ▪ Push Left Control Lever forward and Right Control Lever right to move Right. ▪ Pull Left Control Lever backward to apply a Brake and release to make a Stop. ▪ Push the Left Control Lever forward for a few seconds, the Motorcycle could Stand Up and moves Forward automatically.
PAGE 4
y Only batteries of the same or equivalent type as recommended are to be used. y Batteries are to be inserted with the correct polarity. y Exhausted batteries are to be removed from the unit. Never leave dead or weak batteries in the Vehicle or Transmitter. y The supply terminals are not to be short-circuited. y If you will not be using the Vehicle for several days, remove the batteries. Batteries can leak chemicals that can damage electronic parts.
PAGE 5
The FCC Wants You to Know Your vehicle or transmitter might cause TV or radio interference even when it is operating properly. To determine whether your vehicle or transmitter is causing the interference, turn off your vehicle and the transmitter. If the interference goes away, your vehicle or transmitter is the causing it. Try to eliminate the interference by : y Moving your vehicle and transmitter away from the TV or radio.
PAGE 6