Ceiling Fan With Light User Manual FS6992 CAUTION INSTRUCTIONS CAREFULLY FOR SAFE INSTALLATION AND FAN OPERATION
SAFETY RULES 1. To reduce the risk of electric shock, turn off the electricity to the fan at the main fuse box or circuit panel before beginning. 2. All wiring must be in accordance with the local electrical codes or National Electrical Code. Electrical installation should be performed by a qualified licensed electrician. 3. To avoid personal injury, the use of gloves may be necessary while handling fan parts with sharp edges. 4.
This manual is designed to make it as easy as possible for you to assemble, install, operate and maintain your ceiling fan. Materials ⚠WARNING Before assembling your ceiling fan, refer to sec�on on proper method of wiring your fan . If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician. Wiring outlet box and box connectors must be of type required by the local code.
INSTALL THE FAN Tools Required: Phillips Screwdriver, Pair of Pliers, Straight slot screwdriver, Adjustable Wrench, Step Ladder and Wire Cutters. INSTALL THE MOUNTING BRACKET To prevent personal injury and damage, ensure that the hanging location allows the blade a clearance of 7 feet(2.13 meters) from the floor. If there isn't an existing CUL listed mounting box, then read the following instructions: 1.
How to Install Your Ceiling Fan Remove lamp shade and light source for use After twisting the screw out with a screwdriver, Drive the light source iron plate for backup Pay attention to the direction of the fan blades, which need to be facing upwards Fasten the fan blades with screws on the electric machine After installing the fan blades, reinstall the spare parts in sequence.
INSTALL THE DOWNROD REMEMBER to turn off the power. Follow the steps below to hang your fan properly: 1. Remove the lock pin and hitch pin from down rod. 2. Place down rod assembly into canopy and coupling cover, carefully feed motor wires through the down rod assembly. 3. Loosen the two set screws in down rod coupling. 4. Insert down rod into down rod coupling. Install coupling lock Pin through coupling and down rod. Insert hitch pin into the lock Pin until it snaps into place.
\ Before: 1. Install the Remote OR Wall Switch, DO NOT install both of them. 2. Check circuit fuses or breakers and make sure the battery is installed correctly. 3. Check line wire connections to the fan and switch wire connections in the switch 4. Twist the lampshade counterclockwise into the disc and fix it to complete the installation housing. 5. CAUTION: Make sure the main power is off. Problem: Light does not work 1. Check to see that the wire connections in theswitch housing are connected. 2.
Maintenance 1. Periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning use only a so� brush or lint free cloth to avoid scratching the finish. Abrasive cleaning agents are not required and should be avoided to prevent damage to finish. CAUTION Do not use water to cleaning your ceiling fan. It could damage the motor or the finish and create the possibility of electrical shock.
