Instructions / Assembly

INSTALL THE DOWNROD
REMEMBER to turn off the power. Follow the steps below to hang your
fan properly:
1. Remove the lock pin and hitch pin from down rod.
2. Place down rod assembly into canopy and coupling cover, carefully
feed motor wires through the down rod assembly.
3. Loosen the two set screws in down rod coupling.
4. Insert down rod into down rod coupling. Install coupling lock Pin
through coupling and down rod. Insert hitch pin into the lock Pin until it
snaps into place. Tighten set screws incoupling.
Slide coupling cover over the down rod coupling.
CHANGE DOWNROD (OPT)
Ceiling Fan comes with one 4 inches standard down rod
which is pre-assembled and attached to the hanger ball, one longer 8 inches
down rod is also included for higher ceilings. If you need a different down
rod length, please follow these steps:
1. Loosen the hanger ball from down rod by removing the set screw.
2. Slide down rod ball off of down rod and remove the pin.
3. Re-install pin into extended down rod, and slide down rod ball up to
the top of the down rod.
4. Re-install set screw to secure ball to down rod.
SECURE THE CANOPY
Raise the canopy up and align the keyholes on the bottom of the canopy
with the 2 screws on the bottom of the mounting bracket. Rotate the
canopy until both screws from the mounting bracket drop into the slot
recesses.
Tighten screws securely.