User's Manual
Table Of Contents
- About This Guide
- Get to Know About You Router
- Connect the Hardware
- Log into Your Router
- Set Up Internet Connection
- Guest Network
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- Customize Your Network Settings
- Manage the Router
- 11. 1. Set Up System Time
- 11. 2. Test the Network Connectivity
- 11. 3. Upgrade the Firmware
- 11. 4. Backup and Restore Configuration Settings
- 11. 5. Change the Administrator Account
- 11. 6. Password Recovery
- 11. 7. Local Management
- 11. 8. Remote Management
- 11. 9. System Log
- 11. 10. Monitor the Internet Traffic Statistics
- 11. 11. Control LEDs
- FAQ
19
Chapter 4
Set Up Internet Connection
Tips:
1. If your Internet connection type is BigPond Cable, please go to Advanced > Network > Internet.
2. If you use Dynamic IP and PPPoE and you are provided with any other parameters that are not required on the
page, please go to Advanced > Network > Internet to complete the configuration.
3. If you still cannot connect to the Internet, refer to FAQ for further instructions.
4. 3. Setting Up an IPv6 Internet Connection
Your ISP provides information about one of the following Internet connection types:
PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).
1. Visit http://tplinkwifi.net, then log in with the username and password you set for
the router.
2. Go to Advanced > IPv6.