User's Manual
Table Of Contents
- About This Guide
- Get to Know About You Router
- Connect the Hardware
- Log into Your Router
- Set Up Internet Connection
- Guest Network
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- Customize Your Network Settings
- Manage the Router
- 11. 1. Set Up System Time
- 11. 2. Test the Network Connectivity
- 11. 3. Upgrade the Firmware
- 11. 4. Backup and Restore Configuration Settings
- 11. 5. Change the Administrator Account
- 11. 6. Password Recovery
- 11. 7. Local Management
- 11. 8. Remote Management
- 11. 9. System Log
- 11. 10. Monitor the Internet Traffic Statistics
- 11. 11. Control LEDs
- FAQ
25
Chapter 5
Guest Network
5. 1. Create a Network for Guests
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Advanced > Guest Network. Locate the Wireless section.
3. Create a guest network according to your needs.
1 ) Enable 2.4GHz Wireless network or 5GHz Wireless network.
Note:
Guest network and WDS cannot be enabled at the same time. If WDS was enabled, disable it at Advanced >
System Tools > System Parameters.
2 ) Customize the SSID. Don‘t select Hide SSID unless you want your guests to
manually input the SSID for guest network access.
3 ) Set Security to WPA/WPA2 Personal, keep the default Version and Encryption
values, and customize your own password.
4. Click Save. Now your guests can access your guest network using the SSID and
password you set!
Tips:
To view guest network information, go to Advanced > Status and locate the Guest Network section.