User's Manual
Table Of Contents
- About This Guide
- Get to Know About You Router
- Connect the Hardware
- Log into Your Router
- Set Up Internet Connection
- Guest Network
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- Customize Your Network Settings
- Manage the Router
- 11. 1. Set Up System Time
- 11. 2. Test the Network Connectivity
- 11. 3. Upgrade the Firmware
- 11. 4. Backup and Restore Configuration Settings
- 11. 5. Change the Administrator Account
- 11. 6. Password Recovery
- 11. 7. Local Management
- 11. 8. Remote Management
- 11. 9. System Log
- 11. 10. Monitor the Internet Traffic Statistics
- 11. 11. Control LEDs
- FAQ
4
Chapter 1
Get to Know About You Router
LED Explanation
Name Status Indication
(Power)
On System initialization completes.
Flashing
System initialization or firmware upgrade is in process. Do not
disconnect or power off the router.
Off Power is off.
(2.4GHz Wireless)
On The 2.4GHz wireless band is working properly.
Off The 2.4GHz wireless band is disabled.
( 5GHz Wireless)
On The 5GHz wireless band is working properly.
Off The 5GHz wireless band is disabled.
(Ethernet)
On The Ethernet port is connected.
Off No connection.
(Internet)
Blue On Internet is available.
Orange On
The router’s Internet port is connected, but the Internet
is not available.
Off The router’s Internet port is not connected.
(WPS)
On/Off
Turns On when a WPS synchronization is established and
automatically turns Off about 5 minutes later.
Flashing
A wireless device is trying to connect to the network via WPS. This
process may take up to 2 minutes.