User's Manual
Table Of Contents
- About This Guide
- Get to Know About You Router
- Connect the Hardware
- Log into Your Router
- Set Up Internet Connection
- Guest Network
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- Customize Your Network Settings
- Manage the Router
- 11. 1. Set Up System Time
- 11. 2. Test the Network Connectivity
- 11. 3. Upgrade the Firmware
- 11. 4. Backup and Restore Configuration Settings
- 11. 5. Change the Administrator Account
- 11. 6. Password Recovery
- 11. 7. Local Management
- 11. 8. Remote Management
- 11. 9. System Log
- 11. 10. Monitor the Internet Traffic Statistics
- 11. 11. Control LEDs
- FAQ
75
4. Disable DHCP:
1 ) Go to Network > DHCP Server.
2 ) Deselect Enable DHCP Server and click Save.
Now you can go to Advanced > Status > Wireless to check the WDS status. When the
WDS status is Run, it means WDS bridging is successfully built.
Q5. I cannot access the Internet even though the configuration is
finished, what can I do?
1. Visit http://tplinkwifi.net.
2. Go to Advanced > Status to check Internet status:
As the follow picture shows, if IP Address is a valid one, please try the methods
below and try again: