User's Manual

Archer C3200 AC3200 Wireless Tri-Band Gigabit Router
(USB 1)
Flashing
The router is identifying the device connected to the USB 2.0
port.
On The device is identified successfully.
Off No device is connected to the USB 2.0 port.
(USB 2)
Flashing
The router is identifying the device connected to the USB 3.0
port.
On The device is identified successfully.
Off No device is connected to the USB 3.0 port.
)
)
Note:
After a device is successfully added to the network by WPS function, the WPS LED will keep on
for about 5 minutes and then turn off.
The following buttons are also located on the front panel (View from left to right).
¾
(Wi-Fi): Pressing this button for 2 seconds enables or disables the Wi-Fi function.
¾
(WPS): Pressing this button for less than 5 seconds enables the WPS function. If your
client devices, such as wireless adapters, that support Wi-Fi Protected Setup, then you can
press this button to quickly establish a connection between the router and client devices and
automatically configure wireless security for your wireless network.
¾
(LED On/Off): Pressing this button for 2 seconds turns all LEDs on or off.
1.4.2 Rear Panel
Figure 1-1 Rear Panel sketch
The following parts are located on the rear panel (View from left to right).
¾ Reset: Pressing this button for about 8 seconds enables the Reset function.
- 4 -