User's Manual

Archer C3200 AC3200 Wireless Tri-Band Gigabit Router
the DHCP server function of the router, you must configure all computers on the LAN as "Obtain
an IP Address automatically".
1. Visit http://tplinkwifi.net
, and log in with the password you set for the router.
2. Go to Advanced > Network > DHCP Server page and select IPv4.
3. Enable DHCP and select DHCP Server.
4. Specify the IP Address Pool, the start address and end address must be on the same subnet
with LAN IP. The router will assign addresses within this specified range to its clients. It is
from 192.168.1.100 to 192.168.1.199 by default.
5. Enter a value for the Address Lease Time.
The Address Lease Time is the amount of time in which a DHCP client can lease its current
dynamic IP address assigned by the router. After the dynamic IP address expires, the user
will be automatically assigned a new dynamic IP address. The default is 1440 minutes.
6. Click Save to make the settings effective.
Note:
1. The router can be configured to work as a DHCP Relay. A DHCP relay is a computer that
forwards DHCP data between computers that request IP addresses and the DHCP server
that assigns the addresses. Each of the device's interfaces can be configured as a DHCP
relay. If it is enabled, the DHCP requests from local PCs will forward to the DHCP server that
runs on WAN side.
- 67 -