User's Manual
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log into Your Router
- Set Up Internet Connections
- Guest Network
- USB Application
- Parental Control
- Bandwidth Control
- Network Security
- NAT Forwarding
- Customize Your Network Settings
- Manage the Router
- 12. 1. Set Up System Time
- 12. 2. Test the Network Connectivity
- 12. 3. Upgrade the Firmware
- 12. 4. Backup and Restore Configuration Settings
- 12. 5. Change the Administrator Account
- 12. 6. Local Management
- 12. 7. Remote Management
- 12. 8. System Log
- 12. 9. SNMP Settings
- 12. 10. Monitor the Internet Traffic Statistics
- FAQ
- Specifications
10
Chapter 2
Modem
Power adapter
Po
wer adapter
Router
4
Internet
1
3
2
1 ) Turn off the modem, and remove the backup battery if it has one.
2 ) Connect the modem to the Internet port on your router with an Ethernet cable.
3 ) Turn on the modem, and then wait about 2 minutes for it to restart.
4 ) Turn on the router.
5 ) Verify that the hardware connection is correct by checking these LEDs.
2.4G
On
5G
On
On (Green)
Internet
Power
On
Note:
If the 2.4G LED and 5G LED are off, please press the Wi-Fi On/Off button on the side panel for 2 seconds
and check the LEDs again in a few seconds later.
2. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
Ethernet cable