User's Manual
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log into Your Router
- Set Up Internet Connections
- Guest Network
- USB Application
- Parental Control
- Bandwidth Control
- Network Security
- NAT Forwarding
- Customize Your Network Settings
- Manage the Router
- 12. 1. Set Up System Time
- 12. 2. Test the Network Connectivity
- 12. 3. Upgrade the Firmware
- 12. 4. Backup and Restore Configuration Settings
- 12. 5. Change the Administrator Account
- 12. 6. Local Management
- 12. 7. Remote Management
- 12. 8. System Log
- 12. 9. SNMP Settings
- 12. 10. Monitor the Internet Traffic Statistics
- FAQ
- Specifications
20
Chapter 4
5. Click Save to make the settings take effect. To check your Internet connection, click
Network Map on the left of the page.
Note:
It may take 1-2 minutes to make the settings valid.
6. After the connection succeed, the screen will display as follows. Here we take PPPoE
as an example.
Tips:
1. If your Internet connection type is Bigpond Cable, please go to Advanced > Network > Internet.
2. If you use Dynamic IP and PPPoE and you are provided any other parameters that are not required on the page,
please go to Advanced > Network > Internet to complete the configuration.
3. If you still cannot connect to the Internet, refer to FAQ for further instructions.