User's Manual
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log into Your Router
- Set Up Internet Connections
- Guest Network
- USB Application
- Parental Control
- Bandwidth Control
- Network Security
- NAT Forwarding
- Customize Your Network Settings
- Manage the Router
- 12. 1. Set Up System Time
- 12. 2. Test the Network Connectivity
- 12. 3. Upgrade the Firmware
- 12. 4. Backup and Restore Configuration Settings
- 12. 5. Change the Administrator Account
- 12. 6. Local Management
- 12. 7. Remote Management
- 12. 8. System Log
- 12. 9. SNMP Settings
- 12. 10. Monitor the Internet Traffic Statistics
- FAQ
- Specifications
37
Chapter 6
Tips:
Refer to Set Up a Dynamic DNS Service Account to learn how to set up a domain name for you router.
6. 2. 2. Customize Your Settings
¾ To Only Share Specific Content
By default, Share All is enabled so all content on the USB disk is shared. If you want to
only share specific folders, follow the steps below:
1. Visit http://tplinkwifi.net, then log in with the username and password you’ve set for
the router.
2. Go to Basic > USB Settings > Folder Sharing. Focus on the section of Folder Sharing.
Click the button to disable Share All, then click Add to add a new sharing folder.
3. Select the Volume Name and Folder Path, then specify the Folder Name as you like.
4. Tick Enable Authentication. If you allow network clients to modify this folder, Tick
Enable Write Access.
5. Click OK.
Tips:
The router can share 14 volumes at most. You can click on the page to detach the corresponding volume you do
not need to share.