User's Manual
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect to the Internet
- Login
- Configure the router
- 4. 1. Status
- 4. 2. Network
- 4. 3. Dual Band Selection
- 4. 4. Wireless(2.4Ghz or 5Ghz)
- 4. 5. Guest Network
- 4. 6. DHCP
- 4. 7. Forwarding
- 4. 8. Security
- 4. 9. Parental Controls
- 4. 10. Access Control
- 4. 11. Advanced Routing
- 4. 12. Bandwidth Control
- 4. 13. IP&MAC Binding
- 4. 14. Dynamic DNS
- 4. 15. IPv6
- 4. 16. System Tools
- 4. 17. Logout
- FAQ
4
Chapter 1
LED Explanation
Name Status Indication
(Power)
On System initialization completes.
Flashing
System initialization or firmware upgrade is in progress. Do not
disconnect or power off the router.
Off Power is off.
(Wireless)
On The 2.4GHz wireless function is working properly.
Off The 2.4GHz wireless function is disabled.
(Wireless)
On The 5.0GHz wireless function is working properly.
Off The 5.0GHzwireless function is disabled.
(WPS)
On/Off
Turns on when WPS connection is established, and goes off about 5
minutes later.
Flashing
A wireless device is trying to connect to the network via WPS. This
process may take up to 2 minutes.
(Ethernet)
On One of Ethernet ports is connected.
Off No Ethernet port is connected.
(Internet)
Green On The Internet is available.
Orange On The router’s WAN port is connected, but the Internet is not available.
Off The router’s WAN port is not connected.
1. 2. 2. The Back Panel
The following parts (view from left to right) are located on the rear panel.