User's Manual
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log In to Your Router
- Set Up Internet Connection
- TP-Link Cloud Service
- Guest Network
- USB Settings
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- Customize Your Network Settings
- VPN Server
- Manage the Router
- 14. 1. Set Up System Time
- 14. 2. Test the Network Connectivity
- 14. 3. Upgrade the Firmware
- 14. 4. Backup and Restore Configuration Settings
- 14. 5. Change the Login Password
- 14. 6. Password Recovery
- 14. 7. Local Management
- 14. 8. Remote Management
- 14. 9. System Log
- 14. 10. Monitor the Internet Traffic Statistics
- FAQ
108
FCC ST
ATEMENT
T
his equipmen
t has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
•
R
eor
ient or relocate the receiving antenna.
•
I
ncr
ease the separation between the equipment and receiver.
•
C
onnec
t the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
C
onsult the dealer or an e
xperienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1.
T
his devic
e may not cause harmful interference.
2.
T
his devic
e must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user’s authority to operate the equipment.
FC
C RF R
adiation Exposure Statement
This equipmen
t complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located or
operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to
only Mobile Configurations. The antennas used for this transmitter must be installed to
provide a separation distance of at least 28 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.”
The device is restricted in indoor environment only.