User Manual
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect to the Internet
- Log In
- Configure the Router in Router Mode
- Configure the Router in Access Point Mode
- Configure the Router in Range Extender Mode
- FAQ
68
Chapter 5
1. Visit http://tplinkwifi.net, and log in with password you set for the router.
2. Go to Settings > Wireless > WPS .
5. 4. 1. Use the WPS button
Click WPS start button on the page, and immediately tap the WPS button on your WPS-
supported devices such as Android phones, tablets or most network cards within two
minutes.
5. 4. 2. Set the Router’s PIN
Router’s PIN is enabled by default to allow wireless devices to connect to the router
using the PIN. You can use the default one or generate a new one.
Note:
• If you want to enable/disable the WPS feature, go to System Tools > System Parameters > WPS, check
or uncheck the box for Enable WPS.
• PIN (Personal Identification Number) is an eight-character identification number preset to each router.
WPS supported devices can connect to your router with the PIN. The default PIN is printed on the label
of the router.
5. 4. 3. Use the Client’s PIN
Enter the client’s PIN in the field, and click Connect.