User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the router
- Chapter 3. Quick Setup
- Chapter 4. Basic
- Chapter 5. Advanced
- 5.1 Status
- 5.2 Network
- 5.3 Dual Band Selection
- 5.4 Wireless 2.4GHz
- 5.5 Wireless 5GHz
- 5.6 Guest Network
- 5.7 DHCP
- 5.8 USB Settings
- 5.9 NAT Boost
- 5.10 Forwarding
- 5.11 Security
- 5.12 Parental Control
- 5.13 Access Control
- 5.14 Advanced Routing
- 5.15 Bandwidth Control
- 5.16 IP & MAC Binding
- 5.17 Dynamic DNS
- 5.18 IPv6 Support
- 5.19 System Tools
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
Archer C8
AC1750 Wireless Dual Band Gigabit Router
- 95 -
Note:
Bandwidth Control will become invalid if NAT Boost is enabled. If you want to enable Bandwidth
Control, please go to “Advanced
→
NAT Boost” to disable NAT Boost first.
5.15.1 Control Settings
Choose menu “Advanced
→
Bandwidth Control
→
Control Settings”, and then you can
configure the Egress Bandwidth and Ingress Bandwidth in the next screen. For optimal control of
the bandwidth, please select the right Line Type and ask your ISP for the total bandwidth of the
egress and ingress.
Figure 5-84 Bandwidth Control Settings
Enable Bandwidth Control - Select this checkbox so that the Bandwidth Control settings
can take effect.
Line Type - Select the right type for you network connection. If you don’t know how to choose,
please ask your ISP for the information.
Egress Bandwidth - The upload speed through the Internet port
.
Ingress Bandwidth - The download speed through the Internet port.
5.15.2 Rules List
Choose menu “Advanced
→
Bandwidth Control
→
Rules List”, and then you can view and
configure the Bandwidth Control rules in the screen below.
Figure 5-85 Bandwidth Control Rules List