User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the router
- Chapter 3. Quick Setup
- Chapter 4. Basic
- Chapter 5. Advanced
- 5.1 Status
- 5.2 Network
- 5.3 Dual Band Selection
- 5.4 Wireless 2.4GHz
- 5.5 Wireless 5GHz
- 5.6 Guest Network
- 5.7 DHCP
- 5.8 USB Settings
- 5.9 NAT Boost
- 5.10 Forwarding
- 5.11 Security
- 5.12 Parental Control
- 5.13 Access Control
- 5.14 Advanced Routing
- 5.15 Bandwidth Control
- 5.16 IP & MAC Binding
- 5.17 Dynamic DNS
- 5.18 IPv6 Support
- 5.19 System Tools
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
Archer C9 AC1900 Wireless Dual Band Gigabit Router
- 53 -
ii. Enter ftp://WAN IP:port
in the dialog box and click the OK button.
Note:
If the port for FTP (Remote) is changed, the port for FTP will be changed to the same
port.
Sharing Mode
1) If Share All is selected, all the folders in the USB drive will be shared. Besides
Authentication will appear for you to choose or not.
2) If Share Selected Folders is selected, only the folders you specified will be shared.
5.8.3 Print Server
Choose menu “Advanced→USB Settings→Print Server”, you can enable or disable print server
on the screen below.
Figure 5-48 Pint Server Setting
5.9 NAT Boost
Choose “Advanced→NAT Boost”, and you can enable or disable the NAT boost. It is enabled by
default.
If NAT boost is enabled, the router will have the best throughout. If NAT boost if disabled, the
Bandwidth Control can take effect and it also allows the statistics data to be collected. We do
recommend to enable NAT Boost for the best performance in normal operation.
Figure 5-49 NAT Boost
5.10 Forwarding
Figure 5-50 Forwarding menu