User's Manual Part 2

14
• Point-to-Point
Point-to-Point application is used to build a transparent bridge
between two locations which are far from each other. The gure shown
below is an example for this application.
Refer to the following steps to congure the CPEs.
2. Conguration for Typical Application
This section introduces the congurations for the Point-to-Point
application.
Congure the Access Point
1. Log in to PharOS
2. Go to the Quick Setup page
3. Operation Mode
Select 'Access Point'
Click 'Next'
4. LAN Settings: Click 'Next'
5. Wireless AP Settings
SSID: customize the name for the network as you like
Security: select 'WPA-PSK/WPA2-PSK'
PSK Password: create the password for the network as you like
Distance Setting: enter the distance between the Access Point and
the Client. It is recommended to round the number up to the
nearest integer
Select the MAXtream option if the Access Point and the Client
both are Pharos outdoor CPEs. (Refer to Q4 in FAQ for details about
MAXtream)
Click 'Next'
6. Finsh: Click 'Finish'
IP camera
Access Point
LAN: 192.168.0.254
Client
LAN: 192.168.0.2
Computer