User's Manual

2. Connection and Installation

Please connect and install the device as shown in the gure below. The

following introduction takes CPE520 as an example.

Ethernet cable length up to 60m

You should prepare an adequate

Ethernet cable to connect the CPE

and the passive PoE adapter.

Shielded CAT5e (or above) cable

with ground wire is recommended

(refer to the next section).

Connect to a computer,

router or switch.

(Depending on your

intended usage and/or

network topology.)

At the selected site,

approximately align the CPE

to the direction that you

have oriented.

Slide to replace the cover

of the CPE when all

connections are nished.

LAN0

PoE

LAN