User's Manual
104
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures.
ATTENTION: Due to EU law, the country settings must be identical to the country
where the device is operating (important due to non-harmonised frequencies in the
EU). Restricted to indoor use.
National Restrictions
This device is intended for home and office use in all EU countries (and other countries
following the EU directive 1999/5/EC) without any limitation except for the countries
mentioned below:
Country Restriction
Reason/remark
Bulgaria None General authorization required for outdoor use and public service
France
Outdoor use limited
to 10 mW e.i.r.p.
within the band
2454-2483.5 MHz
Military Radiolocation use. Refarming of the 2.4 GHz band has been
ongoing in recent years to allow current relaxed regulation. Full
implementation planned 2012
Italy
None If used outside of own premises, general authorization is required
Luxembourg
None
General authorization required for network and service supply(not for
spectrum)
Norway
Implemented
This subsection does not apply for the geographical area within a
radius of 20 km from the centre of Ny-Ålesund
Russian Federation
None Only for indoor applications
Note: Please don’t use the product outdoors in France.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil est conforme aux norms CNR exemptes de licence d’Industrie Canada. Le
fonctionnement est soumis aux deux conditions suivantes:
1. cet appareil ne doit pas provoquer d’interférences et
2. cet appareil doit accepter toute interférence, y compris celles susceptibles de
provoquer un fonctionnement non souhaité de l’appareil.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 3 dBi. Antennas not included in this list or having a gain greater than
3 dBi are strictly prohibited for use with this device. The required antenna impedance
is 50 ohms.