User's Guide

3
 LED
There is a System LED on the top of the EAP. The following table explains the indications of
different LED colors.
LED Color Indication
Flashing green System initialization is complete.
Solid green The device is working properly.
Flashing red System errors.
RAM, flash, Ethernet, WLAN or
firmware may be malfunctioning.
Flashing yellow
Firmware update is in progress. Do not
disconnect or power off the device.
Alternating red/green/yellow twice The device is being reset.
2.2.2 Panel Layout
Figure 2-2 Panel Layout of the EAP
The interface panel components of the EAP, from left to right, are described in the following list:
 Kensington Security Slot: Secure the lock (not provided) into the security slot to prevent
the device from being stolen.
 RESET: With the device powered on, press and hold the RESET button for about 8 seconds
until the LED flashes Red/Green/Yellow alternatively twice, then release the button. The
device will restore to factory default settings.
 ETHERNET: This port is used to connect to a router to transmit data or to a PSE device, such
as a switch, for both data transmission and Power over Ethernet (PoE) through Ethernet
cabling.
 POWER: The power port is used connect the device to an electrical wall outlet via power
adapter. Please only use the provided power adapter.
 ARROW 1: This arrow is used to align with ARROW 2 on the mounting bracket to lock the
EAP into place.