User's Guide
Table Of Contents
- Chapter 1 About This Guide
- Chapter 2 Introduction
- Chapter 3 Typical Topology
- Chapter 4 Getting Started with the EAP
- Chapter 5 Management Mode
- Chapter 6 Cluster Mode
- Chapter 7 Standalone Mode
10
5.2.2 Switch from Cluster to Standalone
Log in to the web management page, click Cluster in the navigation tab when the EAP works in
Cluster mode. AP List will be displayed as shown below.
Figure 5-4 Delete an EAP from a Cluster
1. Select the specified EAP in the AP list and click the icon in the Settings column.
2. If the deleted EAP is a Member (shown in the Role column) in the cluster, the mode will
switch to Standalone. To know how to log in to the Member’s web management page, refer
to Chapter 4 Getting Started with the EAP
. If the deleted EAP is a Master in the cluster, the
management mode will switch to Standalone and the login window will pop up.
NOTE:
For detailed information of the Master EAP and Member EAP, please refer to 6.2 Cluster.
5.2.3 Switch from Standalone to Cluster
Log in to the web management page, click Network in the navigation tab when the EAP works
in Standalone mode. The following content will be displayed.