User's Guide
Table Of Contents
- Chapter 1 About This Guide
- Chapter 2 Introduction
- Chapter 3 Typical Topology
- Chapter 4 Getting Started with the EAP
- Chapter 5 Management Mode
- Chapter 6 Cluster Mode
- Chapter 7 Standalone Mode
18
Figure 6-8 Load Balance
Load Balance:
Disable by default. Check the box to enable the function. Then you can
set a number for maximum associated clients to control the wireless
access.
Maximum Associated
Clients:
Enter the number of clients to be allowed for connection to the EAP.
The number ranges from 1 to 99.
SSID Override
Customize the wireless network’s SSID to distinguish it from the cluster’s Service Set Identifier
(SSID), which will help to locate this AP in the wireless network list. Meanwhile, wireless network
can be divided into a specific VLAN based on the SSID. In a network with the same SSID, clients
under the same VLAN can communicate with each other while clients of different VLANs are
separated.
Click , the following content will be shown.