User Manual

09
2. Use a drill bit to drill two holes through the center of your marks. The diameter
of both holes should be 4mm.
Wall
4mm in diameter
Drill Two Holes
3. Insert the plastic extending tubes into the 4mm holes and drive the screws
into the tubes.
4. As Ceiling Mounting shows, press the EAP into the mounting bracket and
turn it clockwise until it locks into place.
5. Simply hang your EAP and the wall mounting is done.
4. Powering Mode
The EAP can be powered via a PSE device (e.g., a PoE switch) or a power adapter.
■
Via PSE Device
EAP220
TL-SG3424P
2
1
Power the EAP via a PoE