User's Manual

IP Address Pool:
Select the IP Pool Name to specify the address range for the server's
IP assignment. This item is available for Server mode.
Remote Subnet:
Enter the IP address range of your remote network. (It's always the IP
address range of LAN on the remote peer of VPN tunnel.) It’s the
combination of IP address and subnet mask.
Status:
Activate or inactivate the entry.
 List of Configurations
In this table, you can view your configurations of the tunnels and edit them by the action buttons.
The No.1 entry in Figure 3-68 indicates: this tunnel is encapsulated by using L2TP. Its user name
is test, the password can be configured, and the router is configured in Client mode. The remote
server is 116.10.10.10 and the remote subnet is 192.168.2.0/24. This entry is enabled.
3.6.3.2 IP Address Pool
On this page, you can configure the IP Address Pool.
Choose the menu VPN→L2TP/PPTP→IP Address Pool to load the following page.
Figure 3-69 IP Address Pool
The following items are displayed on this screen:
 IP Address Pool
Pool Name:
Specify a unique
name to the IP Address Pool for identification and
management purposes.
IP Address Range:
Specify the start and the end IP address for IP Pool. The start IP address
should not exceed the end address and the IP ranges must not overlap.
-103-