User's Manual

 Supports IP-MAC Binding
 Supports GARP (Gratuitous ARP)
 Deploys One-Click restricting of IM/P2P applications
2.3 Appearance
2.3.1 Front Panel
The front panel of TL-ER604W is shown as the following figure.
Figure 2-1 Front Panel
●
LEDs
LED Status Indication
PWR
On
The router is powered on.
Off The router is powered off or power supply is abnormal.
SYS
Flashing
The router works properly.
On/Off The router works improperly.
WLAN
On(Green)
The wireless function is enabled.
Off The wireless function is disabled.
Flashing(Green) There is data being transferred through wireless.
WAN,LAN
On
(Green/Yellow)
There is a device linked to the corresponding port but no activity.
(Green light indicates the linked device is running at 1000Mbps,
and yellow indicates the linked device is running at 10/100Mbps.)
Off
There is no device linked to the corresponding port.
Flashing
(Green/Yellow)
The corresponding port is transmitting or receiving data. (Green
light indicates the linked device is running at 1000Mbps, and
yellow indicates the linked device is running at 10/100Mbps.)
●
Reset button
Use the button to restore the router to the factory defaults. With the router powered on, use a pin to
press and hold the Reset button (about 4~5 seconds). After the SYS LED goes out, release the Reset
button. If the SYS LED is flashing with a high frequency about two or three seconds, it means the router
is restored successfully.
-6-