User's Manual

Host IP Address:
Enter the IP address of the host specified as NAT DMZ server.
3.4.1.2 One-to-One NAT
On this page, you can configure the One-to-One NAT.
Choose the menu Advanced→NAT→One-to-One NAT to load the following page.
Figure 3-35 One to One NAT
The following items are displayed on this screen:

One-to-One NAT
Mapping IP Address:
Enter the Original IP Address in the first checkbox and Translated
IP Address in the second checkbox. TL-ER604W
allows mapping from
LAN port to WAN port in LAN Mode.
Interface:
Select an interface for forwarding data packets.
DMZ Forwarding:
Enable or disable DMZ Forwarding. The packets transmitted to the
Translated IP Address will be forwarded to the host of Original IP if DMZ
Forwarding is enabled.
Description:
Give a description for the entry.
Status:
Activate or inactivate the entry.

List of Rules
In this table, you can view the information of the entries and edit them by the Action buttons.
The first entry in Figure 3-35 indicates: The IP address of host1 in local network is 192.168.0.128
and the WAN IP address after NAT mapping is specified to be 222.135.48.128. The data packets
are transmitted from WAN1 port. DMZ Forwarding and this entry are both activated.
-57-