User's Manual

Note:
One-to-One NAT entries take effect only when the Connection Type of WAN is Static IP. Changing the
Connection type from Static IP to other ones will make the entries attached to the interface disabled.
3.4.1.3 Multi-Nets NAT
Multi-Nets NAT function allows the IP under LAN port within multiple subnets to access the Internet via
NAT.
Choose the menu Advanced→NAT→Multi-Nets NAT to load the following page.
Figure 3-36 Multi-Nets NAT
The following items are displayed on this screen:

Multi-Nets NAT
Subnet/Mask:
Enter the subnet/mask to make the address range for the entry.
Description:
Give a description for the entry.
Status:
Activate or inactivate the entry.

list of Rules
You can view the information of the entries and edit them by the Action buttons.
The first entry in Figure 3-36 indicates that: This is a Multi-Nets NAT entry named tplink1. The
subnet under the LAN port of the router is 192.168.2.0/24 and this entry is activated. After the
corresponding Static Route entry is set, the hosts within this subnet can access the Internet
through the router via NAT.
Note:
 Multi-Nets NAT entry takes effect only when cooperating with the corresponding Static Route
entries.
 For detailed setting of subnet mask, please refer to the Appendix B FAQ.
-58-