User's Manual

 List of RIP
After RIP is enabled, the information of RIP forwarding the packets received by the router will be
displayed in the list.
The first entry in Figure 3-49 indicates: when receiving packets with destination IP is 116.10.20.28,
the router will select WAN1 which is in the same network with the destination IP as next hop and
forward data via this port. The IP address of next hop is 116.10.1.254 and the hop count is 1. The
effective time of this entry is 1 second.
Note:
 RIP function cannot be set if the router is in NAT Mode. To set RIP function, please change the
System Mode to Routing or Full Mode.
 The RIP function of WAN port takes effects only when the Connection Type of this WAN port is
Static IP.
3.4.5.3 Route Table
This page displays the information of the system route table.
Choose the menu Advanced→Routing→Route Table to load the following page.
Figure 3-50 RIP
The following items are displayed on this screen:
 Route Table
Destination:
The Destination of route entry.
Gateway:
The Gateway of route entry.
Flags:
The Flags of route entry. The Flags describe certain characteristics of
the route.
Logical Interface:
The logical interface of route entry.
-77-