User's Guide
Table Of Contents
- Package Contents
- Chapter 1 About this Guide
- Chapter 2 Introduction
- Chapter 3 Configuration
- Chapter 4 Application
- Appendix A Hardware Specifications
- Appendix B FAQ
- Appendix C Glossary
-8-
z
Reset button
Use the button to restore the Router to the factory defaults. With the Router powered on, use a pin to
press and hold the Reset button (about 4~5 seconds). After the SYS LED goes out, release the Reset
button. If the SYS LED is flashing with a high frequency about two or three seconds, it means the Router
is restored successfully.
z
Wifi button
Press this button to enable or disable WI-FI.
2.3.2 Rear Panel
The rear panel of TL-ER604W is shown as the following figure.
Figure 2-2 Rear Panel
z
Antenna
The router provides two external detachable antennas for receiving and transmitting the wireless data.
z
Power
The power socket is where you will connect the power adapter. Please use the power adapter provided
with this TL-ER604W SafeStream
TM
Wireless N Gigabit Broadband VPN Router.
z
On/Off
Press this button to turn on or turn off the Router.
Note:
Please use only the power cord provided with this Router.