User's Guide
Table Of Contents
- Package Contents
- Chapter 1 About this Guide
- Chapter 2 Introduction
- Chapter 3 Configuration
- Chapter 4 Application
- Appendix A Hardware Specifications
- Appendix B FAQ
- Appendix C Glossary
-150-
Choose the menu User Group→User to load the configuration page. Click the <Batch> button to
enter the batch processing screen. Then continue with the following settings:
Settings:
Action: Add
Start IP Address: 192.168.0.30
End IP Address: 192.168.0.50
Prefix Username: User
Start No.: 1
Step: 1
Click the OK button to add the Users in bulk.
Figure 4-10 User Config - Batch
z View
Choose the menu User Group→View to load the configuration page. Add all the Users you just
created into the Group 1 and click the <Save> button to apply.
4.3.3.2 App Control
Choose the menu Firewall→App Control→Control Rules to load the configuration page. Check the
box before Enable Application Control and click <Save> to apply. Then continue with the following
settings:
Settings:
Object: Group
Group: group1