User's Manual
Table Of Contents
- Package contents
- Chapter 1: About this Guide
- 1.1 Purposes
- 1.2 Conventions
- 1.3 Overview of this User Guide
- Chapter 2: Introduction
- Chapter 3: Connecting the Router
- Chapter 4: Quick Installation Guide
- Chapter 5: Configuring the Router
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
- Appendix E: Contact Information
MR0-WR541G 54M Wireless Router User Guide
2.3.2 The Rear Panel
The rear panel contains the following features. (View from right to left:)
¾ AC power socket: only use the power adapter supplied with the MR0-WR541G
54Mbps Wireless Router, use of a different adapter may result in product damage.
¾ Four 10/100Mbps RJ45 LAN ports for connecting the router to the local PCs
¾ RJ45 WAN port for connecting the router to a cable, DSL modem, or Ethernet
¾ Factory Default Reset button
¾ There are two ways to reset the router's factory defaults:
1) Use the Factory Defaults function on System Tools -> Factory Defaults page
in the router's Web-based Utility.
2) Use the Factory Default Reset button: First, turn off the router's power. Second,
press and hold the default reset button then turn on the router's power, until the
SYS LED lights up (about 3 seconds). Last, release the reset button and wait
for the router to reboot.
Note: Ensure the router is powered on before it restarts completely.
¾ Wireless antenna
Figure 2-2 Rear Panel sketch
- 5 -