User's Manual
Table Of Contents
- Package contents
- Chapter 1: About this Guide
- 1.1 Purposes
- 1.2 Conventions
- 1.3 Overview of this User Guide
- Chapter 2: Introduction
- Chapter 3: Connecting the Router
- Chapter 4: Quick Installation Guide
- Chapter 5: Configuring the Router
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
- Appendix E: Contact Information
MR0-WR641G 108M Wireless Router User Guide
¾ SSID - Enter a value of up to 32 characters. The same name (SSID) must be
assigned to all wireless devices in your network. The default SSID is TP-LINK, but
it is recommended strongly that you change your networks name (SSID) to a
different value. This value is case-sensitive. For example, TP-LINK is NOT the
same as tp-link.
¾ Region - Select your region from the pull-down list. This field specifies the region
where the wireless function of the router can be used. It may be illegal to use the
wireless function of the router in a region other than one of those specified in this
field. If your country or region is not listed, please contact your local government
agency for assistance.
The default region is United States. When you select your local region from the
pull-down list, Click the Save button, then the Note Dialog appears. Click
OK.
Note Dialog
Note: Some regions may not use 108Mbps Mode since the operation for the
wireless interface in 108Mbps Mode is illegal. Limited by local law regulations,
version for North America does not have region selection option.
¾ Channel - This field determines which operating frequency will be used. It is not
necessary to change the wireless channel unless you notice interference problems
with another nearby access point.
¾ Mode - Select the desired wireless mode. The options are:
• 108Mbps (Dynamic) - Super G
™
, 802.11g and 802.11b wireless stations can
connect to the router.
• 108Mbps (Static) - Only Super G
™
wireless stations can connect to the router.
• 54Mbps (802.11g) - Both 802.11g and 802.11b wireless stations can connect
to the router.
• 11Mbps (802.11b) - Only 802.11b wireless stations can connect to the router.
Note: The default is "54Mbps (802.11g)", which allows both 802.11g and 802.11b
wireless stations to connect to the router.
¾ Enable Wireless Router Radio - The wireless radio of this Router can be enabled
or disabled to allow wireless stations access. If enabled, wireless stations will be
able to access the router, otherwise, wireless stations will not be able to access.
¾ Enable SSID Broadcast - If you select the Enable SSID Broadcast checkbox, the
Wireless Router SSID will broadcast its name (SSID) on the air.
¾ Enable Wireless Security – The wireless security function can be enabled or
disabled. If disabled, the wireless stations will be able to connect the router without
- 29 -