User's Manual
Table Of Contents
- Chapter 1. Get to Know About Your Router
- Chapter 2. Configure your Touch P5 as a Router
- 2.1 Connect Your Router
- 2.2 Log into Your Router
- 2.3 Quick Setup
- 2.4 Mode Selection
- 2.5 Wireless Settings
- 2.6 WPS
- 2.7 Guest Network
- 2.8 Parental Controls
- 2.9 Devices Control
- 2.10 Printer Server
- 2.11 DDNS
- 2.12 LAN
- 2.13 DHCP Server
- 2.14 QoS
- 2.15 Clock
- 2.16 Screen Settings
- 2.17 Reboot & Reset
- 2.18 Administrator Password
- 2.19 About
- 2.20 USB Application
- 2.21 Set Up IPv6 Connection
- 2.22 NAT Forwarding
- 2.23 Update the Firmware
- Troubleshooting Guide & FAQ
- Appendix A: Specifications
- Appendix B: Glossary
- 空白页面
2.13 DHCP Server
The DHCP Server app can configure the router to act as a DHCP (Dynamic Host Configuration Protocol) server to assign
IP addresses to its clients and view client information from the client list. To use the DHCP server function of the router,
you must configure all computers on the LAN as "Obtain an IP Address automatically".
You can also manually reserve an IP address for a client that is connected to the router. Once reserved, the IP address
will only be assigned to the same client by the DHCP server. If there are some devices in the LAN that require permanent
IP addresses, please configure Address Reservation on the router for the purpose.
1. On the menu screen, tap the DHCP Server icon to open it.
2. Configure the DHCP settings according to your needs.
To set DHCP server of the router:
1. Select DHCP Server.
Chapter 2 Configure your Touch P5 as a Router 33