User's Manual

RE210
AC750 Wi-Fi Range Extender User Guide
 LED Explanation:
Name Status Indication
WPS
Flashing green
WPS connection in progress. It may take up to 2 minutes.
Solid green
The Range Extender has established a secure connection, and the
signal strength is adequate.
Solid orange
The Range Extender has established a secure connection, but the
signal strength is too strong.
Solid red
The Range Extender has established a secure connection, but the
signal strength is too weak.
Off
No active connection.
2.4G
On
The Range Extender is connected to the 2.4G wireless network of
your main Router/AP.
Off
The Range Extender isn’t connected to your main Router/AP.
5G
On
The Range Extender is connected to the 5
G wireless network of
your main Router/AP.
Off
The Range Extender isn’t connected to your main Router/AP.
Power
On
The Range Extender is on.
Off
The Range Extender is off.
Flashing
The Range Extender is initializing.
Ethernet
On
A device is connected to the ETHERNET port.
Off
No device is connected to the ETHERNET port.
Table 1-1
 RE: If your Wireless router or AP supports WPS or QSS function, you can press the WPS or
QSS button and then press the RE button to establish a secure connection between the
Wireless router or AP and the Range Extender RE210.
 Power: The switch for the power.
 Reset: This button is used to restore the Range Extender’s factory default settings.
There are two ways to reset the Range Extender’s factory defaults:
Method One: With the Range Extender powered on, press and hold the Reset button (about
6 seconds) until all the LEDs turn on momentarily, then release the button and wait the Range
Extender to reboot to its factory default settings.
Method Two: Restore the default settings from “System Tools > Factory Defaults” of the
Range Extender's Web-based Management page.
 LED: LED light switch.
 Ethernet: One 10/100/1000Mbps RJ45 Ethernet port used to add wireless connectivity to an
Ethernet-enabled device such as Internet TV, DVR, Gaming console and so on. Please note
that this port is not allowed to be connected with router or AP.
3