User's Manual
Table Of Contents
- Introduction
- Connect the Extender to the Internet
- View the Information of the Extender
- Manage the Extended Network and Security Settings
- More Functions More Functions More Functions
- Manage the Extender
- Appendix Appendix Appendix AppendixAppendix
This device meets the EU requirements (1999/519/EC) on the limitation of
exposure of the general public to electromagnetic fields by way of health
protection.
The device complies with RF specifications when the device used at 20 cm
from your body.
This device is intended for home and office use in all EU countries (and
other countries following the EU directive 1999/5/EC) without any limitation
except for the countries mentioned below:
Country
Restriction
Reason/remark
Belarus
Not implemented
Norway
Implemented
This subsection does not apply for the
geographical area within a radius of 20 km from
the centre of Ny-Ålesund on Svalbard.
Italy
Implemented
The public use is subject to general authorisation
by the respective service provider.
Russian
Federation
Limited
implementation
1. SRD with FHSS modulation
1.1. Maximum 2.5 mW e.i.r.p.
1.2. Maximum 100 mW e.i.r.p. Permitted for use
SRD for outdoor applications without restriction
on installation height only for purposes of
gathering telemetry information for automated
monitoring and resources accounting systems.
Permitted to use SRD for other purposes for
outdoor applications only when the installation
height is not exceeding 10 m above the ground
surface.
1.3.Maximum 100 mW e.i.r.p. Indoor
applications.
2. SRD with DSSS and other than FHSS
wideband modulation
2.1. Maximum mean e.i.r.p. density is 2 mW/MHz.
Maximum 100 mW e.i.r.p.
2.2. Maximum mean e.i.r.p. density is 20
mW/MHz. Maximum 100 mW e.i.r.p. It is
permitted to use SRD for outdoor applications
only for purposes of gathering telemetry
information for automated monitoring and
resources accounting systems or security
systems.
2.3. Maximum mean e.i.r.p. density is 10
mW/MHz. Maximum 100 mW e.i.r.p. Indoor
applications.
Ukraine
Limited
implementation
e.i.r.p. ≤100 mW with built-in antenna with
amplification factor up to 6 dBi.
ATTENTION: Due to EU law, the country settings must be identical to the
country where the device is operating (important due to non-harmonised
frequencies in the EU).
Restricted to indoor use.
This device complies with Industry Canada license-exempt RSSs.
Operation is subject to the following two conditions:
This device may not cause interference, and